blob: 013dac2e2fb131baa83ae883c1eb514c26f55ef1 [file] [log] [blame]
/*
* Board functions for Siemens TAURUS (AT91SAM9G20) based boards
* (C) Copyright Siemens AG
*
* Based on:
* U-Boot file: board/atmel/at91sam9260ek/at91sam9260ek.c
*
* (C) Copyright 2007-2008
* Stelian Pop <stelian@popies.net>
* Lead Tech Design <www.leadtechdesign.com>
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#include <asm/io.h>
#include <asm/arch/at91sam9260_matrix.h>
#include <asm/arch/at91sam9_smc.h>
#include <asm/arch/at91_common.h>
#include <asm/arch/at91_pmc.h>
#include <asm/arch/at91_rstc.h>
#include <asm/arch/gpio.h>
#include <asm/arch/at91sam9_sdramc.h>
#include <asm/arch/clk.h>
#include <linux/mtd/nand.h>
#include <atmel_mci.h>
#include <asm/arch/at91_spi.h>
#include <spi.h>
#include <net.h>
#include <netdev.h>
DECLARE_GLOBAL_DATA_PTR;
static void taurus_nand_hw_init(void)
{
struct at91_smc *smc = (struct at91_smc *)ATMEL_BASE_SMC;
struct at91_matrix *matrix = (struct at91_matrix *)ATMEL_BASE_MATRIX;
unsigned long csa;
/* Assign CS3 to NAND/SmartMedia Interface */
csa = readl(&matrix->ebicsa);
csa |= AT91_MATRIX_CS3A_SMC_SMARTMEDIA;
writel(csa, &matrix->ebicsa);
/* Configure SMC CS3 for NAND/SmartMedia */
writel(AT91_SMC_SETUP_NWE(2) | AT91_SMC_SETUP_NCS_WR(0) |
AT91_SMC_SETUP_NRD(2) | AT91_SMC_SETUP_NCS_RD(0),
&smc->cs[3].setup);
writel(AT91_SMC_PULSE_NWE(4) | AT91_SMC_PULSE_NCS_WR(3) |
AT91_SMC_PULSE_NRD(4) | AT91_SMC_PULSE_NCS_RD(3),
&smc->cs[3].pulse);
writel(AT91_SMC_CYCLE_NWE(7) | AT91_SMC_CYCLE_NRD(7),
&smc->cs[3].cycle);
writel(AT91_SMC_MODE_RM_NRD | AT91_SMC_MODE_WM_NWE |
AT91_SMC_MODE_EXNW_DISABLE |
AT91_SMC_MODE_DBW_8 |
AT91_SMC_MODE_TDF_CYCLE(3),
&smc->cs[3].mode);
/* Configure RDY/BSY */
at91_set_gpio_input(CONFIG_SYS_NAND_READY_PIN, 1);
/* Enable NandFlash */
at91_set_gpio_output(CONFIG_SYS_NAND_ENABLE_PIN, 1);
}
#if defined(CONFIG_SPL_BUILD)
#include <spl.h>
#include <nand.h>
#include <spi_flash.h>
void matrix_init(void)
{
struct at91_matrix *mat = (struct at91_matrix *)ATMEL_BASE_MATRIX;
writel((readl(&mat->scfg[3]) & (~AT91_MATRIX_SLOT_CYCLE))
| AT91_MATRIX_SLOT_CYCLE_(0x40),
&mat->scfg[3]);
}
void at91_spl_board_init(void)
{
taurus_nand_hw_init();
at91_spi0_hw_init(TAURUS_SPI_MASK);
/* Configure recovery button PINs */
at91_set_gpio_input(AT91_PIN_PA31, 1);
/* check if button is pressed */
if (at91_get_gpio_value(AT91_PIN_PA31) == 0) {
struct spi_flash *flash;
debug("Recovery button pressed\n");
nand_init();
spl_nand_erase_one(0, 0);
flash = spi_flash_probe(CONFIG_SF_DEFAULT_BUS,
0,
CONFIG_SF_DEFAULT_SPEED,
SPI_MODE_3);
if (!flash) {
puts("no flash\n");
} else {
puts("erase spi flash sector 0\n");
spi_flash_erase(flash, 0,
CONFIG_SYS_NAND_U_BOOT_SIZE);
}
}
}
void mem_init(void)
{
struct at91_matrix *ma = (struct at91_matrix *)ATMEL_BASE_MATRIX;
struct sdramc_reg setting;
at91_sdram_hw_init();
setting.cr = (AT91_SDRAMC_NC_9 |
AT91_SDRAMC_NR_13 |
AT91_SDRAMC_CAS_3 |
AT91_SDRAMC_NB_4 |
AT91_SDRAMC_DBW_32 |
AT91_SDRAMC_TWR_VAL(3) |
AT91_SDRAMC_TRC_VAL(9) |
AT91_SDRAMC_TRP_VAL(3) |
AT91_SDRAMC_TRCD_VAL(3) |
AT91_SDRAMC_TRAS_VAL(6) |
AT91_SDRAMC_TXSR_VAL(10));
setting.mdr = AT91_SDRAMC_MD_SDRAM;
setting.tr = (CONFIG_SYS_MASTER_CLOCK * 7) / 1000000;
writel(readl(&ma->ebicsa) | AT91_MATRIX_CS1A_SDRAMC |
AT91_MATRIX_VDDIOMSEL_3_3V | AT91_MATRIX_EBI_IOSR_SEL,
&ma->ebicsa);
sdramc_initialize(ATMEL_BASE_CS1, &setting);
}
#endif
#ifdef CONFIG_MACB
static void taurus_macb_hw_init(void)
{
/* Enable EMAC clock */
at91_periph_clk_enable(ATMEL_ID_EMAC0);
/*
* Disable pull-up on:
* RXDV (PA17) => PHY normal mode (not Test mode)
* ERX0 (PA14) => PHY ADDR0
* ERX1 (PA15) => PHY ADDR1
* ERX2 (PA25) => PHY ADDR2
* ERX3 (PA26) => PHY ADDR3
* ECRS (PA28) => PHY ADDR4 => PHYADDR = 0x0
*
* PHY has internal pull-down
*/
at91_set_pio_pullup(AT91_PIO_PORTA, 14, 0);
at91_set_pio_pullup(AT91_PIO_PORTA, 15, 0);
at91_set_pio_pullup(AT91_PIO_PORTA, 17, 0);
at91_set_pio_pullup(AT91_PIO_PORTA, 25, 0);
at91_set_pio_pullup(AT91_PIO_PORTA, 26, 0);
at91_set_pio_pullup(AT91_PIO_PORTA, 28, 0);
at91_phy_reset();
at91_set_gpio_input(AT91_PIN_PA25, 1); /* ERST tri-state */
/* Re-enable pull-up */
at91_set_pio_pullup(AT91_PIO_PORTA, 14, 1);
at91_set_pio_pullup(AT91_PIO_PORTA, 15, 1);
at91_set_pio_pullup(AT91_PIO_PORTA, 17, 1);
at91_set_pio_pullup(AT91_PIO_PORTA, 25, 1);
at91_set_pio_pullup(AT91_PIO_PORTA, 26, 1);
at91_set_pio_pullup(AT91_PIO_PORTA, 28, 1);
/* Initialize EMAC=MACB hardware */
at91_macb_hw_init();
}
#endif
#ifdef CONFIG_GENERIC_ATMEL_MCI
int board_mmc_init(bd_t *bd)
{
at91_mci_hw_init();
return atmel_mci_init((void *)ATMEL_BASE_MCI);
}
#endif
int board_early_init_f(void)
{
/* Enable clocks for all PIOs */
at91_periph_clk_enable(ATMEL_ID_PIOA);
at91_periph_clk_enable(ATMEL_ID_PIOB);
at91_periph_clk_enable(ATMEL_ID_PIOC);
at91_seriald_hw_init();
return 0;
}
int spi_cs_is_valid(unsigned int bus, unsigned int cs)
{
return bus == 0 && cs == 0;
}
void spi_cs_activate(struct spi_slave *slave)
{
at91_set_gpio_value(TAURUS_SPI_CS_PIN, 0);
}
void spi_cs_deactivate(struct spi_slave *slave)
{
at91_set_gpio_value(TAURUS_SPI_CS_PIN, 1);
}
int board_init(void)
{
/* adress of boot parameters */
gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100;
#ifdef CONFIG_CMD_NAND
taurus_nand_hw_init();
#endif
#ifdef CONFIG_MACB
taurus_macb_hw_init();
#endif
at91_spi0_hw_init(TAURUS_SPI_MASK);
return 0;
}
int dram_init(void)
{
gd->ram_size = get_ram_size((void *)CONFIG_SYS_SDRAM_BASE,
CONFIG_SYS_SDRAM_SIZE);
return 0;
}
int board_eth_init(bd_t *bis)
{
int rc = 0;
#ifdef CONFIG_MACB
rc = macb_eth_initialize(0, (void *)ATMEL_BASE_EMAC0, 0x00);
#endif
return rc;
}