blob: 3356c0f072e55da3d80ab9bbd4a051e4deab5ab1 [file] [log] [blame]
/*
* TI QSPI driver
*
* Copyright (C) 2013, Texas Instruments, Incorporated
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#include <asm/io.h>
#include <asm/arch/omap.h>
#include <malloc.h>
#include <spi.h>
#include <asm/gpio.h>
#include <asm/omap_gpio.h>
/* ti qpsi register bit masks */
#define QSPI_TIMEOUT 2000000
#define QSPI_FCLK 192000000
/* clock control */
#define QSPI_CLK_EN (1 << 31)
#define QSPI_CLK_DIV_MAX 0xffff
/* command */
#define QSPI_EN_CS(n) (n << 28)
#define QSPI_WLEN(n) ((n-1) << 19)
#define QSPI_3_PIN (1 << 18)
#define QSPI_RD_SNGL (1 << 16)
#define QSPI_WR_SNGL (2 << 16)
#define QSPI_INVAL (4 << 16)
#define QSPI_RD_QUAD (7 << 16)
/* device control */
#define QSPI_DD(m, n) (m << (3 + n*8))
#define QSPI_CKPHA(n) (1 << (2 + n*8))
#define QSPI_CSPOL(n) (1 << (1 + n*8))
#define QSPI_CKPOL(n) (1 << (n*8))
/* status */
#define QSPI_WC (1 << 1)
#define QSPI_BUSY (1 << 0)
#define QSPI_WC_BUSY (QSPI_WC | QSPI_BUSY)
#define QSPI_XFER_DONE QSPI_WC
#define MM_SWITCH 0x01
#define MEM_CS 0x100
#define MEM_CS_UNSELECT 0xfffff0ff
#define MMAP_START_ADDR_DRA 0x5c000000
#define MMAP_START_ADDR_AM43x 0x30000000
#define CORE_CTRL_IO 0x4a002558
#define QSPI_CMD_READ (0x3 << 0)
#define QSPI_CMD_READ_QUAD (0x6b << 0)
#define QSPI_CMD_READ_FAST (0x0b << 0)
#define QSPI_SETUP0_NUM_A_BYTES (0x2 << 8)
#define QSPI_SETUP0_NUM_D_BYTES_NO_BITS (0x0 << 10)
#define QSPI_SETUP0_NUM_D_BYTES_8_BITS (0x1 << 10)
#define QSPI_SETUP0_READ_NORMAL (0x0 << 12)
#define QSPI_SETUP0_READ_QUAD (0x3 << 12)
#define QSPI_CMD_WRITE (0x2 << 16)
#define QSPI_NUM_DUMMY_BITS (0x0 << 24)
/* ti qspi register set */
struct ti_qspi_regs {
u32 pid;
u32 pad0[3];
u32 sysconfig;
u32 pad1[3];
u32 int_stat_raw;
u32 int_stat_en;
u32 int_en_set;
u32 int_en_ctlr;
u32 intc_eoi;
u32 pad2[3];
u32 clk_ctrl;
u32 dc;
u32 cmd;
u32 status;
u32 data;
u32 setup0;
u32 setup1;
u32 setup2;
u32 setup3;
u32 memswitch;
u32 data1;
u32 data2;
u32 data3;
};
/* ti qspi slave */
struct ti_qspi_slave {
struct spi_slave slave;
struct ti_qspi_regs *base;
unsigned int mode;
u32 cmd;
u32 dc;
};
static inline struct ti_qspi_slave *to_ti_qspi_slave(struct spi_slave *slave)
{
return container_of(slave, struct ti_qspi_slave, slave);
}
static void ti_spi_setup_spi_register(struct ti_qspi_slave *qslave)
{
struct spi_slave *slave = &qslave->slave;
u32 memval = 0;
#if defined(CONFIG_DRA7XX) || defined(CONFIG_AM57XX)
slave->memory_map = (void *)MMAP_START_ADDR_DRA;
#else
slave->memory_map = (void *)MMAP_START_ADDR_AM43x;
slave->op_mode_rx = 8;
#endif
#ifdef CONFIG_QSPI_QUAD_SUPPORT
memval |= (QSPI_CMD_READ_QUAD | QSPI_SETUP0_NUM_A_BYTES |
QSPI_SETUP0_NUM_D_BYTES_8_BITS |
QSPI_SETUP0_READ_QUAD | QSPI_CMD_WRITE |
QSPI_NUM_DUMMY_BITS);
#else
memval |= QSPI_CMD_READ | QSPI_SETUP0_NUM_A_BYTES |
QSPI_SETUP0_NUM_D_BYTES_NO_BITS |
QSPI_SETUP0_READ_NORMAL | QSPI_CMD_WRITE |
QSPI_NUM_DUMMY_BITS;
#endif
writel(memval, &qslave->base->setup0);
}
static void ti_spi_set_speed(struct spi_slave *slave, uint hz)
{
struct ti_qspi_slave *qslave = to_ti_qspi_slave(slave);
uint clk_div;
debug("ti_spi_set_speed: hz: %d, clock divider %d\n", hz, clk_div);
if (!hz)
clk_div = 0;
else
clk_div = (QSPI_FCLK / hz) - 1;
/* disable SCLK */
writel(readl(&qslave->base->clk_ctrl) & ~QSPI_CLK_EN,
&qslave->base->clk_ctrl);
/* assign clk_div values */
if (clk_div < 0)
clk_div = 0;
else if (clk_div > QSPI_CLK_DIV_MAX)
clk_div = QSPI_CLK_DIV_MAX;
/* enable SCLK */
writel(QSPI_CLK_EN | clk_div, &qslave->base->clk_ctrl);
}
int spi_cs_is_valid(unsigned int bus, unsigned int cs)
{
return 1;
}
void spi_cs_activate(struct spi_slave *slave)
{
/* CS handled in xfer */
return;
}
void spi_cs_deactivate(struct spi_slave *slave)
{
struct ti_qspi_slave *qslave = to_ti_qspi_slave(slave);
debug("spi_cs_deactivate: 0x%08x\n", (u32)slave);
writel(qslave->cmd | QSPI_INVAL, &qslave->base->cmd);
}
void spi_init(void)
{
/* nothing to do */
}
struct spi_slave *spi_setup_slave(unsigned int bus, unsigned int cs,
unsigned int max_hz, unsigned int mode)
{
struct ti_qspi_slave *qslave;
#ifdef CONFIG_AM43XX
gpio_request(CONFIG_QSPI_SEL_GPIO, "qspi_gpio");
gpio_direction_output(CONFIG_QSPI_SEL_GPIO, 1);
#endif
qslave = spi_alloc_slave(struct ti_qspi_slave, bus, cs);
if (!qslave) {
printf("SPI_error: Fail to allocate ti_qspi_slave\n");
return NULL;
}
qslave->base = (struct ti_qspi_regs *)QSPI_BASE;
qslave->mode = mode;
ti_spi_set_speed(&qslave->slave, max_hz);
#ifdef CONFIG_TI_SPI_MMAP
ti_spi_setup_spi_register(qslave);
#endif
return &qslave->slave;
}
void spi_free_slave(struct spi_slave *slave)
{
struct ti_qspi_slave *qslave = to_ti_qspi_slave(slave);
free(qslave);
}
int spi_claim_bus(struct spi_slave *slave)
{
struct ti_qspi_slave *qslave = to_ti_qspi_slave(slave);
debug("spi_claim_bus: bus:%i cs:%i\n", slave->bus, slave->cs);
qslave->dc = 0;
if (qslave->mode & SPI_CPHA)
qslave->dc |= QSPI_CKPHA(slave->cs);
if (qslave->mode & SPI_CPOL)
qslave->dc |= QSPI_CKPOL(slave->cs);
if (qslave->mode & SPI_CS_HIGH)
qslave->dc |= QSPI_CSPOL(slave->cs);
writel(qslave->dc, &qslave->base->dc);
writel(0, &qslave->base->cmd);
writel(0, &qslave->base->data);
return 0;
}
void spi_release_bus(struct spi_slave *slave)
{
struct ti_qspi_slave *qslave = to_ti_qspi_slave(slave);
debug("spi_release_bus: bus:%i cs:%i\n", slave->bus, slave->cs);
writel(0, &qslave->base->dc);
writel(0, &qslave->base->cmd);
writel(0, &qslave->base->data);
}
int spi_xfer(struct spi_slave *slave, unsigned int bitlen, const void *dout,
void *din, unsigned long flags)
{
struct ti_qspi_slave *qslave = to_ti_qspi_slave(slave);
uint words = bitlen >> 3; /* fixed 8-bit word length */
const uchar *txp = dout;
uchar *rxp = din;
uint status;
int timeout;
#if defined(CONFIG_DRA7XX) || defined(CONFIG_AM57XX)
int val;
#endif
debug("spi_xfer: bus:%i cs:%i bitlen:%i words:%i flags:%lx\n",
slave->bus, slave->cs, bitlen, words, flags);
/* Setup mmap flags */
if (flags & SPI_XFER_MMAP) {
writel(MM_SWITCH, &qslave->base->memswitch);
#if defined(CONFIG_DRA7XX) || defined(CONFIG_AM57XX)
val = readl(CORE_CTRL_IO);
val |= MEM_CS;
writel(val, CORE_CTRL_IO);
#endif
return 0;
} else if (flags & SPI_XFER_MMAP_END) {
writel(~MM_SWITCH, &qslave->base->memswitch);
#if defined(CONFIG_DRA7XX) || defined(CONFIG_AM57XX)
val = readl(CORE_CTRL_IO);
val &= MEM_CS_UNSELECT;
writel(val, CORE_CTRL_IO);
#endif
return 0;
}
if (bitlen == 0)
return -1;
if (bitlen % 8) {
debug("spi_xfer: Non byte aligned SPI transfer\n");
return -1;
}
/* Setup command reg */
qslave->cmd = 0;
qslave->cmd |= QSPI_WLEN(8);
qslave->cmd |= QSPI_EN_CS(slave->cs);
if (flags & SPI_3WIRE)
qslave->cmd |= QSPI_3_PIN;
qslave->cmd |= 0xfff;
/* FIXME: This delay is required for successfull
* completion of read/write/erase. Once its root
* caused, it will be remove from the driver.
*/
#ifdef CONFIG_AM43XX
udelay(100);
#endif
while (words--) {
if (txp) {
debug("tx cmd %08x dc %08x data %02x\n",
qslave->cmd | QSPI_WR_SNGL, qslave->dc, *txp);
writel(*txp++, &qslave->base->data);
writel(qslave->cmd | QSPI_WR_SNGL,
&qslave->base->cmd);
status = readl(&qslave->base->status);
timeout = QSPI_TIMEOUT;
while ((status & QSPI_WC_BUSY) != QSPI_XFER_DONE) {
if (--timeout < 0) {
printf("spi_xfer: TX timeout!\n");
return -1;
}
status = readl(&qslave->base->status);
}
debug("tx done, status %08x\n", status);
}
if (rxp) {
qslave->cmd |= QSPI_RD_SNGL;
debug("rx cmd %08x dc %08x\n",
qslave->cmd, qslave->dc);
#ifdef CONFIG_DRA7XX
udelay(500);
#endif
writel(qslave->cmd, &qslave->base->cmd);
status = readl(&qslave->base->status);
timeout = QSPI_TIMEOUT;
while ((status & QSPI_WC_BUSY) != QSPI_XFER_DONE) {
if (--timeout < 0) {
printf("spi_xfer: RX timeout!\n");
return -1;
}
status = readl(&qslave->base->status);
}
*rxp++ = readl(&qslave->base->data);
debug("rx done, status %08x, read %02x\n",
status, *(rxp-1));
}
}
/* Terminate frame */
if (flags & SPI_XFER_END)
spi_cs_deactivate(slave);
return 0;
}