blob: 04191dff1e6f9fb0e0f780c42da98c8ddb458778 [file] [log] [blame] [edit]
/*
* (C) Copyright 2008
* Dirk Eibach, Guntermann & Drunck GmbH, eibach@gdsys.de
*
* Based on board/amcc/yosemite/yosemite.c
* (C) Copyright 2006-2007
* Stefan Roese, DENX Software Engineering, sr@denx.de.
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#include <asm/ppc4xx.h>
#include <asm/processor.h>
#include <asm/io.h>
#include <asm/4xx_pci.h>
DECLARE_GLOBAL_DATA_PTR;
/* info for FLASH chips */
extern flash_info_t flash_info[CONFIG_SYS_MAX_FLASH_BANKS];
int board_early_init_f(void)
{
register uint reg;
/*
* Setup the external bus controller/chip selects
*/
mfebc(EBC0_CFG, reg);
mtebc(EBC0_CFG, reg | 0x04000000); /* Set ATC */
/*
* Setup the GPIO pins
*/
/* setup Address lines for flash size 64Meg. */
out32(GPIO0_OSRL, in32(GPIO0_OSRL) | 0x54000000);
out32(GPIO0_TSRL, in32(GPIO0_TSRL) | 0x54000000);
out32(GPIO0_ISR1L, in32(GPIO0_ISR1L) | 0x54000000);
/* setup emac */
out32(GPIO0_TCR, in32(GPIO0_TCR) | 0xC080);
out32(GPIO0_TSRL, in32(GPIO0_TSRL) | 0x40);
out32(GPIO0_ISR1L, in32(GPIO0_ISR1L) | 0x55);
out32(GPIO0_OSRH, in32(GPIO0_OSRH) | 0x50004000);
out32(GPIO0_ISR1H, in32(GPIO0_ISR1H) | 0x00440000);
/* UART0 and UART1*/
out32(GPIO1_TCR, in32(GPIO1_TCR) | 0x16000000);
out32(GPIO1_OSRL, in32(GPIO1_OSRL) | 0x02180000);
out32(GPIO1_ISR1L, in32(GPIO1_ISR1L) | 0x00400000);
out32(GPIO1_ISR2L, in32(GPIO1_ISR2L) | 0x04010000);
/* disable boot-eeprom WP */
out32(GPIO0_OSRL, in32(GPIO0_OSRL) & ~0x00C00000);
out32(GPIO0_TSRL, in32(GPIO0_TSRL) & ~0x00C00000);
out32(GPIO0_ISR1L, in32(GPIO0_ISR1L) & ~0x00C00000);
out32(GPIO0_TCR, in32(GPIO0_TCR) | 0x08000000);
out32(GPIO0_OR, in32(GPIO0_OR) & ~0x08000000);
/* external interrupts IRQ0...3 */
out32(GPIO1_TCR, in32(GPIO1_TCR) & ~0x00f00000);
out32(GPIO1_TSRL, in32(GPIO1_TSRL) & ~0x00005500);
out32(GPIO1_ISR1L, in32(GPIO1_ISR1L) | 0x00005500);
/*
* Setup the interrupt controller polarities, triggers, etc.
*/
mtdcr(UIC0SR, 0xffffffff); /* clear all */
mtdcr(UIC0ER, 0x00000000); /* disable all */
mtdcr(UIC0CR, 0x00000009); /* ATI & UIC1 crit are critical */
mtdcr(UIC0PR, 0xfffffe13); /* per ref-board manual */
mtdcr(UIC0TR, 0x01c00008); /* per ref-board manual */
mtdcr(UIC0VR, 0x00000001); /* int31 highest, base=0x000 */
mtdcr(UIC0SR, 0xffffffff); /* clear all */
mtdcr(UIC1SR, 0xffffffff); /* clear all */
mtdcr(UIC1ER, 0x00000000); /* disable all */
mtdcr(UIC1CR, 0x00000000); /* all non-critical */
mtdcr(UIC1PR, 0xffffe0ff); /* per ref-board manual */
mtdcr(UIC1TR, 0x00ffc000); /* per ref-board manual */
mtdcr(UIC1VR, 0x00000001); /* int31 highest, base=0x000 */
mtdcr(UIC1SR, 0xffffffff); /* clear all */
/*
* Setup other serial configuration
*/
mfsdr(SDR0_PCI0, reg);
mtsdr(SDR0_PCI0, 0x80000000 | reg); /* PCI arbiter enabled */
mtsdr(SDR0_PFC0, 0x00003e00); /* Pin function */
mtsdr(SDR0_PFC1, 0x00048000); /* Pin function: UART0 has 4 pins */
return 0;
}
int misc_init_r(void)
{
uint pbcr;
int size_val;
uint sz;
/* Re-do sizing to get full correct info */
mfebc(PB0CR, pbcr);
if (gd->bd->bi_flashsize > 0x08000000)
panic("Max. flash banksize is 128 MB!\n");
for (sz = gd->bd->bi_flashsize, size_val = 7;
((sz & 0x08000000) == 0) && (size_val > 0); --size_val)
sz <<= 1;
pbcr = (pbcr & 0x0001ffff) | gd->bd->bi_flashstart | (size_val << 17);
mtebc(PB0CR, pbcr);
/* adjust flash start and offset */
gd->bd->bi_flashstart = 0 - gd->bd->bi_flashsize;
gd->bd->bi_flashoffset = 0;
/* Monitor protection ON by default */
(void)flash_protect(FLAG_PROTECT_SET,
-CONFIG_SYS_MONITOR_LEN,
0xffffffff,
&flash_info[0]);
return 0;
}
int checkboard(void)
{
char buf[64];
int i = getenv_f("serial#", buf, sizeof(buf));
printf("Board: GDPPC440ETX - G&D PPC440EP/GR ETX-module");
if (i > 0) {
puts(", serial# ");
puts(buf);
}
putc('\n');
return 0;
}
/*
* Override weak pci_pre_init()
*/
#if defined(CONFIG_PCI)
int pci_pre_init(struct pci_controller *hose)
{
/* First call common code */
__pci_pre_init(hose);
/* enable 66 MHz ext. Clock */
out32(GPIO1_TCR, in32(GPIO1_TCR) | 0x00008000);
out32(GPIO1_OR, in32(GPIO1_OR) | 0x00008000);
return 1;
}
#endif /* defined(CONFIG_PCI) */